Hi guys by miura69
write this little manualino to set a minimum alpha AWUS036H
under windows are sometimes overlooked some of these small details, but on occasion can make a difference
regarding the stability of the wireless connection, whereas
often in default parameters are not ideal for
or European standards for our personal needs
"We organize networks show" Click "Change advanced "
now on general panel CLICK " configure" then "Advanced "
Perfect! channel on channel 6 checked, since it is more or less central
of all (between 1-13 channel) otherwise put the No.
channel corresponding to the access point to which you are or you need to log!
now on channel plans checked ETSI
( E uropean T elecommunications S tandards I nstitute )
in some cases, you must enable " IBBSS default mode 11b "
Change to Power Save Mode
you have 3 options 1) " CAM for medium distances, radio waves are constant and stable
2) "FAST- PSP " short distances, in theory, would reduce the radio noise
3) "MAX- PSP for long distances, get to pick up signals further away
But the airwaves are less stable and unstable +.
For those who use the utility Realtek a photo with similar parameters 
MORE TIPS:
I reserve the right to say that these suggestions are dictated by personal experiences
we can not guarantee the same results in all situations
CAUSE: The Alpha see the network to which we have linked above, but will not connect despite
is automatic.
SOLUTION: go to the wireless icon at the bottom and enter the command "restore"
Otherwise, disconnect the USB cable and reconnect it after a few minutes
CAUSE: A network to which we previously linked to stroke
.. " not connect to the network signal weak or nonexistent "
SOLUTION: Repeat the steps above, (change IP, etc., etc.)
perhaps change the drivers, then re-replace them again
with earlier installed, check that the channel of the access-point
ALSO:
1) Never use the alpha AWUS036H without the antenna connected
( rule applies to any wi-fi adapter )
the risk is high, you can burn the final internal adapter
cause breakage and making the adapter useless
2) under Linux is very normal that the internal LED is not flashing like in Windows
3) Even today in some pre-sales customer asks me
adapter is not part of the bad batch of ' October 2008
It was only a very small lot and that date, so if you only
controlled purchases of used parts and check the data plate
the back, now for some time NO seller provides more
articles dating back to dates so far from the current .
4) The 'alpha AWUS036H now has a cable with a single input
the old usb cable Y with 2 usb plugs was provided only to
for a possible bad power supply of the old USB 1.1 ports, with USB 2.0
this problem does not exist!
PS: I apologize in advance for any my technical errors, but new suggestions are welcome
parameters to use, and any clarifications
perhaps underlined by me!
_________________
0 comments:
Post a Comment